|
How to Cut a Cigar
Cigar cutters are used to remove or penetrate the cap of a cigar before smoking it. There are three basic types of cuts, the straight cut, the wedge (or V) cut, and the hole punch. The type of cut to make is based on personal preference and the size and/or shape of the cigar. Experienced cigar smokers may not always make the same type of cut or use the same kind of cutter. The straight cut is the most common, and is always preferred on cigars with a small ring gauge (thin cigars).
1. Straight Cigar Cutters - The most basic type of cutter used to make straight cuts is the single blade guillotine. The double blade guillotine is preferred by many aficionados because it usually makes a cleaner cut. Cigar scissors are also used to make straight cuts, and may be the best choice for cutting the cigar at the exact spot you intend. However, the guillotines are usually the most practical, the least expensive, and can be easily and safely carried in the pocket of your shirt or trousers.
2. "V" Cut or "Wedge" Cutter - The wedge or "V" cutter resembles the guillotine cutter, but the shape of the blade slices a wedge into the cap of the cigar instead of cutting it completely off. The cutter is designed to slice from one side, and at the same depth, so there is no danger of cutting too deep.
3. Hole Punch - The hole punch is used to put a hole in the cap of the cigar, instead of cutting it off. If the hole is not large enough for the cigar, the draw of smoke through the cigar can be impeded. Also, as the cigar is smoked, tar can accumulate near the hole, also affecting the taste as well as the draw. Here's a hot tip: In a pinch when no cutter is available, or to sample a hole punched cigar without buying a hole punch device, a hole cut can be made in a cigar using a pen or pencil.
Making the Cut
The closed end (or head) of a cigar is the end that you put into your mouth, but you have to cut it, first. When a cigar is hand rolled, a cap is put on the head of the cigar to keep it from unraveling and drying out. A cigar should not be cut until you are ready to smoke. There are three styles of cuts, and several types of cutters, but the straight cut made with a guillotine cutter is the most common. Hold the cigar with one hand and the guillotine with the other, then insert the head of the cigar into the guillotine and cut into the cap, usually about 1/16 to 1/8 of an inch down. If the head of the cigar is shaped like a cone, then cut into the cone, but not quite at the widest part. In any case, do not cut into the body of the cigar. That would cause the wrapper to unravel, and ruin your smoking experience.
No Cigar Cutter?
The most primitive way of cutting the head of a cigar with absolutely no tools is to bite it with your teeth. This is a last resort, and should never be done with an expensive premium cigar, as the cigar is much more valuable than a basic cutter. Biting a cigar, or otherwise cutting it improperly, will cause the wrapper to unravel, and could even damage the binder and filler tobacco inside. If available, use a sharp knife and a cutting board, or a pair of sharp scissors. You can also use a pen or pencil to punch a hole in the cap. If the cigar costs more than $5, do not cut it until you have a cigar cutter. It will be worth the wait.
|
